The stone cnc router machine has gradually become a good helper for stone processing, and some unnecessary troubles will inevitably occur in the operation. Then, what are the precautions for novices to operate the stone cnc router machine?
一, stone cnc router machine operation process
1. Before using the stone cnc router machine, be sure to check the lubricity of the cnc router machine tool accessories and whether the protection device of the stone cnc router machine can meet the engraving needs.
2. In the process of operating the stone cnc router machine, be sure to observe whether the stone cnc router machine and other accessories show signs of loosening. If signs of loosening are found, the operation of the stone cnc router machine should be stopped immediately to prevent damage during processing. The product causes an impact and causes unnecessary losses to the factory.
3. After the speed of the stone cnc router machine reaches a certain high speed, attention should be paid to the environment around the cnc router machine to prevent unnecessary collisions.
4. After encountering the abnormal noise of the machine engine, the cnc router machine should be stopped immediately to check whether it is the cause of the machine itself.
5. In the process of stone processing, the cnc router machine machine itself cannot stack some tools, workpieces, etc. casually. It is forbidden to touch the rotating parts when rotating, and the machine cannot be tilted on the machine.
6. After the operation is completed, carefully wipe the machine, and after cleaning the work site, disconnect the power supply.
二. Matters needing attention for engraving and cutting of stone cnc router machine
1. Stone carving. The use of stone for carving usually refers to inverse carving, and the cnc router machine has a deeper carving depth when engraving. When performing stone carving, the power of the cnc router machine is generally set higher. If it encounters hard stone, the color of the carved figure may become darker. If you want to make the engraving stone lighter, you can increase the engraving speed appropriately and perform several more operations. Because the material of the stone is different, some stone will wear out some oily fume when it is engraved by the cnc router machine. You can use a wet rag to wipe it off carefully. If there is no paint on the engraved stone, it may not be wiped clean when wiping. , Destroy the surface of the finished product and affect the sale.
2, stone cutting. The cutting depth of the stone cnc router machine is generally not very deep when cutting the stone. If it is cutting very thick stone, the cutting depth can be appropriately slowed down and the cutting is carried out in layers, which may cause the stone cnc router machine tool to break. The specific operation can be carried out hierarchically with common sense, slow down the cutting speed of the cnc router machine, and cut by repeating the knife.
Through the above understanding, everyone’s understanding of stone cnc router machine will become more profound. Only a good cnc router machine can effectively guarantee our production efficiency.
